UP Beaver Creek Bridge (Beaver)


Click the photo to view the full-size version

1/18
Date Taken:
Author:
Caption:

Name UP Beaver Creek Bridge (Beaver)
Chicago & North Western Railway Bridge #713
Built By Chicago & North Western Railway
Currently Owned By Union Pacific Railroad
Superstructure Contractor American Bridge Company of New York (Lassig Plant)
Substructure Contractor Widell Company of Mankato, Minnesota
Unknown (Concrete Repairs)
Length 136 Feet Total
Width 2 Tracks
Height Above Ground 10 Feet (Estimated)
Superstructure Design Deck Plate Girder
Substructure Design Stone Masonry and Concrete
Date Built 1900-01
Traffic Count 50 Trains/Day (Estimated)
Current Status In Use
Chicago & North Western Railway Bridge Number 713
Union Pacific Railroad Bridge Number 220.02
Significance Local Significance
Documentation Date 10/22/2017

In 1867, the Cedar Rapids & Missouri River Railroad (CR&MR) continued constructing a mainline westward from Boone, Iowa.  In the late 1850s and early 1860s, the CR&MR had participated in constructing a line from Clinton, Iowa to Boone.  The CR&MR was leased by the Chicago & North Western Railway (C&NW), which was seeking a route connecting Chicago to the Missouri River.  In 1867, an impressive 150 miles were constructed between Boone, Iowa and Council Bluffs, Iowa, completing a connection between Chicago and the Missouri River.  The line also allowed for a short spur from Missouri Valley, Iowa to the Missouri River opposite of Blair, Nebraska.  This spur would eventually be extended across the Missouri River and into Nebraska.  Between 1869 and 1872, Union Pacific Railroad (UP) constructed a bridge across the Missouri River between Council Bluffs and Omaha, Nebraska; and the C&NW obtained trackage rights over the bridge to reach Omaha.  During the second half of the 19th Century, the C&NW had constructed and acquired a large amount of trackage throughout the Midwest.   In 1884, the CR&MR was formally purchased by the C&NW; and this line quickly became a core asset of the C&NW system.  

By the late 19th Century, traffic over this line had increased to the point significant upgrades were required.  In 1893, a 5-mile section of railroad was relocated west of Jefferson, Iowa to improve grades and eliminate curves.  One of the most significant barriers to efficient operation over this line was the Des Moines River Valley between Boone and Ogden, Iowa.  The original route crossed the Des Moines River at Moingona, which was approached by winding and steep approaches on each bank.  In 1899, C&NW subsidiary Boone County Railway (BCR) began construction on a more direct route between Boone and Ogden, Iowa; including a massive viaduct across the Des Moines River.  The BCR was consolidated into the C&NW in 1900, and the new cutoff was completed in May 1901.  The new alignment shortened the route by 3 miles, cut grades in half and only required two small curves.  The original mainline through Moingona was maintained as an emergency backup and to serve industries in the area.  Between 1901 and 1902, a second track was also constructed between Ogden and Council Bluffs, including a 5-mile realignment near Arcadia, Iowa.  The double tracking of this line provided the C&NW with a well constructed double track mainline between Chicago and Council Bluffs.  

By the 20th Century, the C&NW was operating an extensive railroad network, which radiated north and west from Chicago.  The original mainline into Moingona was abandoned in 1930.  This line served as the backbone of the C&NW, connecting transcontinental freight and passengers at Omaha to Chicago.  Known as the Overland Route, this line became one of the most significant railroad routes in the United States.  This route saw continuous upgrades during the 20th Century, including significant bridge, rail, tie and signal upgrades.  In 1995, the C&NW was purchased by UP, which provided UP with a mainline into the railroad hub of Chicago.  Into the 21st Century, the line has seen continuous upgrades, and remains one of the most significant railroad lines in the United States.  Today, UP operates this line as the Boone Subdivision between Boone and Missouri Valley; and the Omaha Subdivision between Missouri Valley and Council Bluffs.


Located in the small town of Beaver, this deck plate girder bridge carries a former Chicago & North Western Railway mainline over Beaver Creek. The first bridge at this location was a timber pile trestle bridge, constructed when the line was first built. As traffic over this line grew in the 1870s and 1880s, the C&NW made several improvements to timber bridges, replacing them with iron and stone structures. It is unclear if this bridge was rebuilt with a stone and iron structure, or if it remained a timber bridge until the end of the 19th Century. Between 1898 and 1902, the C&NW undertook a large double tracking project between Cedar Rapids, Iowa and Council Bluffs, Iowa. In 1900, new stone substructures were constructed, and in 1901, the present deck plate girder spans were placed. Currently, the bridge consists of two double track 68-foot deck plate girder spans, set onto stone and concrete piers and abutments. The superstructure follows a standard design, consisting of two heavy plate girders per track and an open deck. The substructures have been heavily altered with various concrete repairs, but originally used a standard design with a diamond shaped pier and stepped wing walls at the abutments. Stone for the substructures consists of a yellow limestone, likely quarried at Mankato, Minnesota. American Bridge Company fabricated the superstructure at their Lassig Plant in Chicago, while it is believed that the Widell Company constructed the substructures. Between the late 1890s and approximately 1903, this company is reported to have constructed much of the stone bridges and culverts along the Iowa Division. Deck plate girder spans were popular for railroad use, as they were durable and easy to construct. In the mid-20th Century, several alterations were made to the bridge, including the replacement of the backwalls with concrete, encasement of the center pier in concrete and encasement of the abutments in concrete. Based on other bridges along this line, it is likely that these improvements were made in stages between the mid-1940s and early 1960s. Overall, the bridge appears to be in fair to good condition, with no significant deterioration noted. The author has ranked this bridge as being locally significant, due to the common design.


Citations

Build date Chicago & North Western Railway Valuation Notes at the Chicago & North Western Historical Society Archives
Builder (superstructure) Missing American Bridge Company (Lassig Plant) plaque
Builder (substructure) The Improvement Bulletin; November 18, 1899
Railroad History Citation ICC Valuation Information, Compiled by Richard S. Steele

Loading...