| Name | UP Deer Creek Bridge (Tama) Chicago & North Western Railway Bridge #394 |
| Built By | Chicago & North Western Railway |
| Currently Owned By | Union Pacific Railroad |
| Superstructure Contractor | Lassig Bridge & Iron Works of Chicago |
| Substructure Contractor | Widell Company of Mankato, Minnesota (Abutments and East and West Pier) Unknown (Center Pier) |
| Length | 210 Feet Total, 60 Foot Main Spans |
| Width | 2 Tracks |
| Height Above Ground | 15 Feet (Estimated) |
| Superstructure Design | Through Plate Girder |
| Substructure Design | Stone Masonry and Concrete |
| Date Built | 1900; Center Pier Reconstructed 1925 |
| Traffic Count | 50 Trains/Day (Estimated) |
| Current Status | In Use |
| Chicago & North Western Railway Bridge Number | 394 |
| Union Pacific Railroad Bridge Number | 133.61 |
| Significance | Local Significance |
| Documentation Date | 11/13/2016 |
In 1856, the Chicago, Iowa & Nebraska Rail Road (CI&N) began construction on a new mainline across Iowa, connecting an existing Galena & Chicago Union Railroad (G&CU) line at Fulton, Illinois to the Missouri River. To establish construction, a temporary ferry was installed across the Mississippi River at Clinton in 1856. In 1857, the first 44 miles were completed to Wheatland, Iowa. The following year, 20 miles were completed to Lisbon, Iowa; and in 1859, an addition 17 miles were completed to Cedar Rapids, Iowa. In 1861, the Cedar Rapids & Missouri River Railroad (CR&MR) constructed an additional 41 miles to Chelsea, Iowa; followed by 29 miles to Marshalltown, Iowa in 1862. After pausing in 1863, an additional 29 miles were completed to Nevada, Iowa in 1864, followed by 23 additional miles to Boone, Iowa in 1865. In 1864, both the CI&N and CR&MR were leased by the Chicago & North Western Railway (C&NW). In 1867, the line continued west from Boone, reaching the Missouri River at Council Bluffs, Iowa in 1867.
During the second half of the 19th Century, the C&NW had constructed and acquired a large amount of trackage throughout the Midwest. This line formed a principal mainline for the C&NW, connecting western railroads at Omaha to the railroad hub of Chicago. In 1884, the C&IN and CM&MR were formally acquired by the C&NW. In 1887, the Linn County Railway (LC) constructed a 6-mile cutoff, bypassing Cedar Rapids to the south between Otis, Iowa and Beverly, Iowa. At the end of the year, the LC was formally acquired by the C&NW. During the late 19th Century, several other improvements were made to this line. Between 1890 and 1891, a second track was constructed between Clinton and Lowden, Iowa; and between Libson and the Cedar River bridge. Between 1893 and 1894, a second track was constructed between Lowden and Lisbon. A second track was added to the original mainline through Cedar Rapids in 1898, and between 1898 and 1899, a second track was constructed between the Cedar River bridge and the west side of Marshalltown. In 1901, a second track was completed between Marshalltown and Boone, and new facilities were constructed at Boone. Throughout the 20th Century, the Cedar River bridge remained a gauntlet structure, severely hindering efficient operations.
By the 20th Century, the C&NW was operating an extensive railroad network, which radiated north and west from Chicago. This line served as the backbone of the C&NW, connecting transcontinental freight and passengers at Omaha to Chicago. Known as the Overland Route, this line became one of the most significant railroad routes in the United States. This route saw continuous upgrades during the 20th Century, including significant bridge, rail, tie and signal upgrades. In 1995, the C&NW was purchased by Union Pacific Railroad (UP). In 2002, UP constructed a second track at the Cedar River bridge, eliminating a single track bottleneck in the network. Today, this line remains vital to UP and is still well maintained. The Clinton to Boone segment is known as the Clinton Subdivision, and remains a heavily used double track mainline.
Located on the west side of Tama, this through plate girder bridge carries a former Chicago & North Western Railway mainline over Deer Creek. The first bridge at this location was likely a timber pile trestle, constructed when the line was first built. It is likely that the original bridge was replaced by an iron bridge during the late 1870s or early 1880s. It is possible that this bridge was an iron double intersection Warren pony truss, typical of early iron spans constructed for the C&NW. Between 1898 and 1902, the C&NW undertook a large double tracking project between Cedar Rapids, Iowa and Council Bluffs, Iowa. As part of the project, the original single track bridge was replaced by the present double track structure. It is unclear if any potential predecessor iron spans were reused at other locations. Throughout the 20th Century, the bridge saw a number of alterations, including the reconstruction of the center pier in 1925; strengthening of the superstructure in 1929 and 1943, and raising the superstructure with new bearing blocks in the mid-20th Century. Currently, the bridge consists of two 60-foot through plate girder spans, approached by a 45-foot through plate girder span on either end. The outer piers and abutments are constructed of stone, while the inner pier is constructed of concrete.
The superstructure follows a standard design for the era, with two heavy plate girders per span, square girder ends and a standard floor system. Because of the different sizes, the outer girders are slightly smaller than the inner girders. The floor system uses two heavy I-beam stringers per track, which appear to have been added in 1949 and are a different grade of steel than the girders. The outer piers use a typical diamond shape, with angled noses on both sides. The abutments also use a standard design, with stepped wing walls which extend at an angle from the bridge. The center pier also uses a standard diamond shape, and it is unclear if the center pier simply was encased or if it was entirely reconstructed in 1925. The superstructure is supported by tall bearing blocks, and the center of each span is supported by steel cylinders which form a jack system. Stone for the substructures consists of a yellow limestone, quarried at Mankato, Minnesota. Lassig Bridge & Iron Works fabricated the superstructure as part of a contract for many bridges along this line. The Widell Company constructed the stone substructures, while the center pier was rebuilt by an unknown contractor. Between the late 1890s and approximately 1903, the Widell Company is reported to have constructed much of the stone bridges and culverts along the Iowa Division. Through plate girder spans were popular for railroad use, as they were durable and easy to construct. Since the initial construction, the bridge has seen a number of alterations, which are detailed above. Today, it remains in use as part of a Union Pacific Railroad mainline. Overall, the bridge appears to be in fair to good condition, with no significant deterioration noted. The author has ranked the bridge as being locally significant, due to the common design.
Citations
| Build date | Chicago & North Western Railway Drawing Collection at the Chicago & North Western Historical Society Archives |
| Builder (superstructure) | Missing Lassig Bridge & Iron Works plaque |
| Builder (stone substructure) | Mankato Free Press; May 5, 1899 |
| Railroad History Citation | ICC Valuation Information, Compiled by Richard S. Steele |